Deck sealing complete

-
After three coats I felt okay about the deck but not the floor. Some parts of the floor were good and others pretty dry.

So I sanded it (an the sides) down and re-coated it.



Took a moment here to consult with my boss.


Then concluded that the floor looked pretty good and now the decks needed some work so I sanded them down and applied another layer....




Much better! This was the roller I used in the end, expensive but produced a much better result than the standard foam rollers.



Comments

Post a Comment

Popular posts from this blog

Upgrade to control lines

-
Image
One big annoyance from my first few sails has been the combination on continuous lines and rail mounted cleats. The cleats are uncomfortable to sit on and much worse kept coming uncleared. The main cause of uncleating being over exuberant use of the continuous lines pulling on the backside of the far cleats. Once the cleats on the rail are undone you have to reach them to recleat, likely a problem as your weight goes to the wrong place. Looking at rigging pictures I found images of Daryl’s Farr on face book where the cleats were centerline and led through eyes at the rail. This seemed to fix all my primary issues so I decided to copy.  Original layout: Removed and holes filled. Also marked out an extra area for more non skid: At this point I commented on Daryl’s picture and he replied that he no longer ran lines through the eyes, but instead to low friction rings on elastic. As I thought about this made a lot of sense as it would allow more control from outboa...
Read more

Last thing on the list... break it

-
Image
I had a scrappy piece of paper with my final "get it on the water" checklist and Vida added her own item.... I'd always joked with the kids that Farrout would get broken and repaired many times, partly just to get them used to the idea that this was fine (like capsizing, or falling off your bike). Anyway.... To work off some Jetlag I took Farrout for  a lovely winters day sail. By the time I got on the water the wind had died down a bit from it's midday peak but it was still strong enough to have us skipping across the harbor. First things first I needed to do was test some of the changes I'd made. Improvements to rigging setup:  Great! Fast setup of shrouds, quick attachment of rudder, boat breaker line just the right length. Took 20 minutes to rig and next time will be quicker as it's tuned already! New Zhik sea boots: Comfy, but not the extra grip I was hoping for. Going to have to extend the foot rests higher to get better purchase I think....
Read more

Rudder Pt II (III and IV to come I guess)

-
Image
" Hopefully can finish up fairing tomorrow" I said, four days ago! Turn out that the I beam mod took a lot more sanding and reshaping to get back to a good shape, probably about four hours total with three layers of epoxy filler in there. But finally it's ready to skin again.... That join isn't great but hey most of these are cored in foam the strength will be in the three layers of carbon cloth the top part of the foil is going to end up with.
Read more

Album